how to change renault cvt fk0 1/1 fluid

 FK0 or FK8

IMPORTANT Consult the safety and cleanliness advice and operation recommendations before carrying out any repair.

 

Note: When draining, filling or checking the oil level, always shift the gear lever to the Park position.

 

Note: The oil level must be checked at a temperature between 50ºC and 80ºC.

DRAINING

• Position the vehicle on a two-post lift.

IMPORTANT To prevent the vehicle from falling, lash it to the vehicle lift using a strap.

• Remove the engine undertray.

• Remove:
  • the drain plug (1) ,
  • the O-ring from the drain plug.
• Drain the automatic gearbox.
• Refit:
  • the new O-ring on the drain plug,
  • the drain plug.
• Torque tighten the drain plug (34 N.m).

FILLING

• Remove the air inlet sleeve.

• Remove the oil level gauge (2) from the automatic variable gearbox.
• Top up the automatic gearbox oil to the specified level using the oil charging pipe (3) .
• Check the oil level using the automatic gearbox oil level gauge (2) after heating the automatic gearbox oil to a temperature between 50ºC and 80ºC.
• Refit:
  • the oil level gauge,
  • the engine undertray.
• Connect the Diagnostic tool. For programming procedures (see Fault finding - Replacement of components.

CHECKING THE OIL LEVEL

• Wait until the temperature of the automatic gearbox oil is between 50ºC and 80ºC.
• Put the gear lever in the Park position.
• Run the engine at idle speed.
• Firmly apply the parking brake.
• Move the gear lever to the D position.
• Remove the oil level dipstick.
• Clean the oil level dipstick.

• Refit the dipstick, rotated 180º from its initial position.

• Check the automatic gearbox oil level on the dipstick.

http://www.rkoleos.com/284/automatic_gearbox_identification.html